Inicio
Hay 253 productos.
Filtros activos
Foxeer ELRS 915/868MHz Receiver
Matek DroneCAN-Digital power monitor
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
ToolkitRC ADP 200 AC to DC Adapter
Input voltage:AC 100-240V 50/60Hz
Input current:MAX 2.5A
Output voltage:MAX 19.5V
Output current:MAX 10.3A
Connector:XT60
Size:165mm * 77mm * 32mm
Wight:518g
Work temp:-10 - 40'C
Radiomaster 2S 7.4V 6200mAh Lipo Battery
Servicio de Impermeabilización de tu Dron
Te impermeabilizamos tu dron, y lo testeamos en un entorno seguro. Si eliges este servicio no te preocupas de nada, nos encargamos de organizar la recogida del dron en tu casa, y te lo mandamos una vez este impermeabilizado ¡Sin gasto extra para ti!
RadioMaster 5000mAh 2s Li-ion battery pack
The RadioMaster 5000mAh 2s Li-ion battery pack is the perfect battery for your Radiomaster TX16S. Offering longer run times and safer use when compared to Li-poly batteries.
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
Happymodel ES900RX 868MHz
This Long Range 868MHz wireless transmission module is designed based on Open source software ExpressLRS. It is compatible with most OpenTX radios, especially the TX16S from Radiomaster.
Matek 2812 Led Controller V2
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).
Happymodel Micro ES900TX and ES900RX module 868MHz
Matek UBEC Duo, 4A/5-12V
Matek Power Module 20S
PM20S-2 is made with 100V DC components.
Support 9V to 85V DC operating Input voltage with 85V TVS protection
2x independent Step-Down Voltage Regulators
Regulator 1 , 5.3V / 6.1V / 8.1V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
Regulator 2 , 5.3V / 8.1V / 12.2V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
1K:25K voltage divider built-in for 3.3V based voltage ADC
Size & Weight: 61x40x15mm, 63g