Inicio
Hay 8 productos.
Filtros activos
Airbot cable 8 pins 3cm
El cable sirve principalmente para conectar el FC y los ESC 4 en 1.
Accesorios recomendados para productos Airbot (y otros con conector de 8 pines)
Mamba Universal parts package
Conjunto de componentes para montar cualquier tipo de stack FC+ESC M2 o M3 a falta de unos tornillos del largo que uses.
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
Diatone Mamba Soldering Practice Board
Radiomaster 2S 7.4V 6200mAh Lipo Battery
Radiomaster RP3 V2
The RP3 receiver features a Skyworks SE2431L providing an LNA for improved receiver performance, a PA providing up to 100mW of telemetry performance and antenna switching for antenna diversity.
Radiomaster RP1 V2
The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.
Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!