Inicio
Hay 15 productos.
Filtros activos
Airbot Omnibus F4 V6
La versión de actualización de OMNIBUS F4, utilizando F405, con 5x UART.
El diseño clásico de OMNIBUS, utilizando F4 MCU controla el OSD sobre el bus SPI, comparado a la primera versión, agregamos BMP280 como barómetro y soporte para tarjetas SD.
Configuración del OSD ha sido incluida en Betaflight GUI.
Airbot cable 8 pins 3cm
El cable sirve principalmente para conectar el FC y los ESC 4 en 1.
Accesorios recomendados para productos Airbot (y otros con conector de 8 pines)
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Omnibus F4 V6 + Furling32 4in1 45A
CNHL 1500mAh 4S 100C BLACK SERIES
CNHL 1500mAh 6S 100C BLACK SERIES
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
CNHL 1300mAh 6S 100C BLACK SERIES
CNHL MiniStar 650mAh 4S 70C XT30
CNHL MiniStar 850mAh 4S 70C XT30
CNHL MiniStar 1500mAh 4S 120C
Radiomaster 2S 7.4V 6200mAh Lipo Battery
Radiomaster RP3 V2
The RP3 receiver features a Skyworks SE2431L providing an LNA for improved receiver performance, a PA providing up to 100mW of telemetry performance and antenna switching for antenna diversity.
Radiomaster RP1 V2
The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.
Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!