Controladores de vuelo

Bocina / Buzzer

The fourth version of the SpeedyBee stack includes an FC F405 and a BLHeli_S 55A ESC. The 30x30mm stack can support up to eight motors, is configured via Bluetooth, has a bult-in barometer as well as an ICM42688P gyro. The SpeedyBee F405 V4 stack is both complete and inexpensive, all with good performance. Always equipped with a Bluetooth controller allowing settings via the mobile application, the stack also has a TVS diode protecting the electronics. Integrated LEDs indicate the battery charge level and 2 3A BECs provide a 5V and 9V power supply.

9Módulo GPS / Glonass de precisión para betaflight o pixhawk.

La versión de actualización de OMNIBUS F4, utilizando F405, con 5x UART.

El diseño clásico de OMNIBUS, utilizando F4 MCU controla el OSD sobre el bus SPI, comparado a la primera versión, agregamos BMP280 como barómetro y soporte para tarjetas SD.

Configuración del OSD ha sido incluida en Betaflight GUI.

Gomas anti-vibración para controlador de vuelo M3

La controladora más nueva de Fettec. Con OSD integrado y compatible con vídeo digital de DJI y vídeo analógico.

Gomas anti vibración para controlador de vuelo con agujeros de M2

Conjunto de componentes para montar cualquier tipo de stack FC+ESC M2 o M3 a falta de unos tornillos del largo que uses.

Solderfree connection from FETtec FC to FETtec ESC

FETtec OSD Board. Full KISS tunning, live data graphs (Voltage, motor rpm, current, motor temp, gyro values, link quality).

This is the iNav recommended small GPS/Compass module.  It features the Beitian BN-880 GPS module, with HMC5883l I2C compass module.  This module arrives ready to use with iNav/Betaflight.  Just select the baud rate in the settings to be 38400.

Features an F7 processor, onboard spaces for both VTX and RX, Pit-mode built-in for Unify Nano, and solder-free connection to FETtec 4-in-1 ESC.

A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode,  Supports 6x UART