Receivers
There are 44 products.
BETAFPV ELRS 2.4G Lite Receiver
BETAFPV Lite receiver is based on the ExpressLRS project, an open-source RC link for RC applications. ExpressLRS aims to achieve the best possible link performance in both speeds, latency, and range. This makes ExpressLRS one of the fastest RC links available while still offering long-range performance.
BETAFPV ELRS 2.4G V1.2 Micro Receiver
BETAFPV Micro receiver is based on the ExpressLRS project, an open-source RC link for RC applications. ExpressLRS aims to achieve the best possible link performance in both speeds, latency, and range. This makes ExpressLRS one of the fastest RC links available while still offering long-range performance.
BETAFPV ELRS Lite RX/2.4GHz Flat antenna
BETAFPV ELRS Nano Receiver
BETAFPV Nano receiver is based on the ExpressLRS project, an open-source RC link for RC applications. ExpressLRS aims to achieve the best possible link performance in both speeds, latency, and range. This makes ExpressLRS one of the fastest RC links available while still offering long-range performance.
BETAFPV ExpressLRS Recovery Dongle
ExpressLRS Recovery Dongle is an FTDI USB to TTL module based on the CP2102 bridge controller, which is applied to the firmware upgrade for the ESP32&ESP8XX chip. The ExpressLRS Recovery Dongle is compatible with many ELRS receivers in the market such as ELRS Lite Receiver, ELRS Nano Receiver, ELRS Micro Receiver, and FPV goggles backpack. It will be a good choice to unbrick the ELRS receiver when failed in updating or flash firmware by UART.
BETAFPV SPI Frsky Receiver
BETAFPV SuperD ELRS 2.4G Diversity Receiver
BETAFPV SuperD ELRS 2.4G is the world's first True Diversity Receiver that applies two antennas, dual receiver chains, and TCXO (temperature compensated crystal oscillator) tech, achieving super accurate frequency rate and excellent performance in extreme temperature environments. It greatly fulfills the requirements of reliability for long range flying, aerial photography, or FPV freestyle tricks
ES900RX 868MHz - Module by Happymodel
This Long Range 868MHz wireless transmission module is designed based on Open source software ExpressLRS. It is compatible with most OpenTX radios, especially the TX16S from Radiomaster.
ETHIX MAMBO Starter Set
FlySky FS-iA8X 2.4GHz AFHDS 2A iBUS PPM Micro Receiver
This is FlySky's smallest and lightest receiver.
FlySky FS-X14S 14-Channels 2.4GHZ DIVERSITY MICRO RECEIVER
FlySky FS-X14S 14 channel remote control receiver, compatible with FlySky FS-I6 NV14 FS-I6X FS-i4 FS-I4X Transmitter.
FlySky FS-X6B 2.4G 6CH i-BUS PPM PWM Receiver
FS-X6B is a 6 channel two-way receiver designed for multi-rotor aircraft. It uses the AFHDS 2A(Automatic Frequency Hopping Digital System) protocol and dual omnidirectional antenna with superior noise reduction techniques. It's compact, easy to install and boasts a rich easy to use interface. FS-X6B support 6 channel PWM output, standard PPM output and i-BUS support for up to 18 channels alongside a reliable voltage sensor interface.
FlySky IA10B
This full 10 channel receiver works for most models and is considered a "full range" so it can handle larger models as well as the smaller ones. Built in connections allow you to use our optional telemetry sensors. Dual antennas give the FS-iA10 for unparalleled reception. Easy binding, light weight, optional telemetry, dual antennas.
FlySky IA6
FlySky FS-iA6 6ch Receiver - Dual Antennas
FlySky IA6B
This FlySky FS-iA6B 6ch Receiver works great with the FlySky FS-i6 Controller. This compact 6 channel receiver is great for any model using up to 6 channels and, with a range exceeding 500 meters, it can be considered to be full range for all but the most demanding of applications. The receiver has end-on connectors to enable a neat installation in tight spaces. Built in connectors allow you to use any of the optional FlySky telemetry sensors. Dual antennas give the FS-iA6B excellent reception and interference rejection capability. With easy binding, compact dimensions, optional telemetry and dual antennas!