Home
Active filters
FlySky FS-i6S
The FlySky FS-i6S is a 10CH 2.4GHz Radio Controller
TRUERC Core 5.8
80mm Antenna, SMA connector, RHCP.
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
TrueRC X-Ray 5.8
The X-RAY 5.8 is a new development of our X-AIR technology. A single feed panel format with very low side lobes, maximizing main lobe efficiency.
FlySky IA6B
This FlySky FS-iA6B 6ch Receiver works great with the FlySky FS-i6 Controller. This compact 6 channel receiver is great for any model using up to 6 channels and, with a range exceeding 500 meters, it can be considered to be full range for all but the most demanding of applications. The receiver has end-on connectors to enable a neat installation in tight spaces. Built in connectors allow you to use any of the optional FlySky telemetry sensors. Dual antennas give the FS-iA6B excellent reception and interference rejection capability. With easy binding, compact dimensions, optional telemetry and dual antennas!
TrueRC Singularity 5.8
The singularity 5.8 is our most advanced antenna. We pushed miniaturization further than ever before, yet managed to push performances a notch higher still.
TrueRC Sniper II 5.8
The new SNIPER 5.8 is our latest redesign of the sniper antenna.
TrueRC X-AIR 5.8 MK II pair for DJI GOGGLES 2 - LHCP
A pair of X-air that fit right on the DJI goggles 2 for massive range boost.
TrueRC Duality 2.4/5.8 Stubby for DJI
TrueRC never stop! The duality is a dual band CP omni covering both 2.4 and 5.8GHz bands in a single compact stubby package. Drop-in fit on the DJI FPV goggles V2*, letting you leaving them on at all times, thanks to a much lower profile than the stock linear antennas.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
FlySky FS-X6B 2.4G 6CH i-BUS PPM PWM Receiver
FS-X6B is a 6 channel two-way receiver designed for multi-rotor aircraft. It uses the AFHDS 2A(Automatic Frequency Hopping Digital System) protocol and dual omnidirectional antenna with superior noise reduction techniques. It's compact, easy to install and boasts a rich easy to use interface. FS-X6B support 6 channel PWM output, standard PPM output and i-BUS support for up to 18 channels alongside a reliable voltage sensor interface.