Home
Active filters
Airbot Omnibus F4 V6
OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.
classic OMNIBUS design, using F4 MCU controls OSD over SPI bus, compare the first version, we added BMP280 as barometer and SD Card supports.
OSD Configuration has been incl. in Betaflight GUI.
Airbot cable 8 pins 3cm
The cable serves primarily to connect the FC and the 4in1 controllers.
Recommended accessories for Airbot products (and others with 8-pin connector)
TrueRC X-Ray 5.8
The X-RAY 5.8 is a new development of our X-AIR technology. A single feed panel format with very low side lobes, maximizing main lobe efficiency.
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Omnibus F4 V6 + Furling32 4in1 45A
TrueRC Singularity 5.8
The singularity 5.8 is our most advanced antenna. We pushed miniaturization further than ever before, yet managed to push performances a notch higher still.
TrueRC Sniper II 5.8
The new SNIPER 5.8 is our latest redesign of the sniper antenna.
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
TrueRC X-AIR 5.8 MK II pair for DJI GOGGLES 2 - LHCP
A pair of X-air that fit right on the DJI goggles 2 for massive range boost.
TrueRC Duality 2.4/5.8 Stubby for DJI
TrueRC never stop! The duality is a dual band CP omni covering both 2.4 and 5.8GHz bands in a single compact stubby package. Drop-in fit on the DJI FPV goggles V2*, letting you leaving them on at all times, thanks to a much lower profile than the stock linear antennas.
TRUERC Core 5.8
80mm Antenna, SMA connector, RHCP.