Home
Active filters
Airbot Omnibus F4 V6
OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.
classic OMNIBUS design, using F4 MCU controls OSD over SPI bus, compare the first version, we added BMP280 as barometer and SD Card supports.
OSD Configuration has been incl. in Betaflight GUI.
Airbot cable 8 pins 3cm
The cable serves primarily to connect the FC and the 4in1 controllers.
Recommended accessories for Airbot products (and others with 8-pin connector)
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
SpeedyBee F7 V3 Flight Controller
SpeedyBee F7 V3 BL32 50A 4-in-1 ESC
SpeedyBee Adapter 3
SpeedyBee F7 Mini 35A 3-6S 8-bit Flight Controller Stack
SpeedyBee F7 V3 BL32 50A 30x30 Stack
Flycolor X Cross 80A HVIII
SpeedyBee F405 WING APP Fixed Wing Flight Controller
SpeedyBee F405 V4 BLS 55A 30x30 FC&ESC Stack
The fourth version of the SpeedyBee stack includes an FC F405 and a BLHeli_S 55A ESC. The 30x30mm stack can support up to eight motors, is configured via Bluetooth, has a bult-in barometer as well as an ICM42688P gyro. The SpeedyBee F405 V4 stack is both complete and inexpensive, all with good performance. Always equipped with a Bluetooth controller allowing settings via the mobile application, the stack also has a TVS diode protecting the electronics. Integrated LEDs indicate the battery charge level and 2 3A BECs provide a 5V and 9V power supply.
Flycolor Trinx G5 60A 4in1
Current: 60A*4
Burst: 70A*4
Voltage: 3-6S
ESC MCU: STM32G071
ESC firmware: Flycolor_Raptor_5
All D-shot, Pro-shot