Back In Stock

Fat goggle strap so your FPV goggles strap on tight while you teleport to another dimension!

TATTU 450mAh 14.8V 75C 4S1P Lipo Battery Pack--Long Size suitable for Multirotor FPV 150 size, suitable for BetaFPV HX115 HD, BetaFPV Beta85X, Beta95X, perfect for small Cinewhoops in the 85 and 95mm size or toothpicks, and Flitz F5k. 

A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode,  Supports 6x UART

Fat goggle strap so your FPV goggles strap on tight while you teleport to another dimension!

Connector Amass XT60H-F female

KitCopter Velcro Strap Kevlar V2 - 30x2 cm negro

FS-X6B is a 6 channel two-way receiver designed for multi-rotor aircraft. It uses the AFHDS 2A(Automatic Frequency Hopping Digital System) protocol and dual omnidirectional antenna with superior noise reduction techniques. It's compact, easy to install and boasts a rich easy to use interface. FS-X6B support 6 channel PWM output, standard PPM output and i-BUS support for up to 18 channels alongside a reliable voltage sensor interface.

Sometimes you got that special project with special screws you dont have bits for. This 24bits kit might be able to help you out. Any workbench should have a set just in case!

3M pads (4 units)

The SOURCE TWO is the 2nd open source frame, this time focusing on lightweight and racing. The frame is donated to the community to empower creators and makers, and integrate best practices and current trends faster into a continuously manufactured product.

Screw Set for Source ONE V3/HD carbon frame.

Super grippy, sticky battery pads for different size quads (cut to your own size).

Super grippy, sticky battery pads for your micro builds.