Flight controllers

Bocina / Buzzer

The fourth version of the SpeedyBee stack includes an FC F405 and a BLHeli_S 55A ESC. The 30x30mm stack can support up to eight motors, is configured via Bluetooth, has a bult-in barometer as well as an ICM42688P gyro. The SpeedyBee F405 V4 stack is both complete and inexpensive, all with good performance. Always equipped with a Bluetooth controller allowing settings via the mobile application, the stack also has a TVS diode protecting the electronics. Integrated LEDs indicate the battery charge level and 2 3A BECs provide a 5V and 9V power supply.

Precision GPS / Glonass module for betaflight or pixhawk.

OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.

classic OMNIBUS design, using F4 MCU controls OSD over SPI bus, compare the first version, we added BMP280 as barometer and SD Card supports.

OSD Configuration has been incl. in Betaflight GUI.

Antivibration dampers for flight controller with M3 holes.

Newest Fettec FC. Integrated OSD and compatible with DJI digital video and analog video.

Antivibration dampers for flight controller with M2 holes.

Set of components to mount any type of FC + ESC M2 or M3 stack in the absence of screws of the length you use.

Solderfree connection from FETtec FC to FETtec ESC

FETtec OSD Board. Full KISS tunning, live data graphs (Voltage, motor rpm, current, motor temp, gyro values, link quality).

This is the iNav recommended small GPS/Compass module.  It features the Beitian BN-880 GPS module, with HMC5883l I2C compass module.  This module arrives ready to use with iNav/Betaflight.  Just select the baud rate in the settings to be 38400.

Features an F7 processor, onboard spaces for both VTX and RX, Pit-mode built-in for Unify Nano, and solder-free connection to FETtec 4-in-1 ESC.

A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode,  Supports 6x UART