Inicio

Filtros activos

  • Categorías: Componentes
  • Categorías: Drones
86,74 €
En stock

F722 35A AIO Brushless Flight Controller is very reliable to meet your advanced FPV needs. Comes with an F722 chip this board provides a great performance capability and high processing speed, which brings pilots a stable and smooth flight. Featuring a 6-pin plug&play port, it can directly connect HD Digital VTX with NO soldering work. With the support of up to 6S input voltage, this FC pushes FPV racer to the max. 

15,66 €
En stock

The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.

Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!

5,74 €
En stock

If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).

49,55 €
En stock

PM20S-2 is made with 100V DC components.

Support 9V to 85V DC operating Input voltage with 85V TVS protection

2x independent Step-Down Voltage Regulators

Regulator 1 ,  5.3V / 6.1V / 8.1V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

Regulator 2 ,  5.3V / 8.1V / 12.2V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

1K:25K voltage divider built-in for 3.3V based voltage ADC

Size & Weight: 61x40x15mm, 63g

20,62 €
En stock

RGB LED Status

[Rainbow fade effect], Starting Up

[Green heartbeat], Web update mode enabled

[Slow blink 500ms on/off ], Waiting for connection from transmitter

[Red flashing 100ms on/off], Radio chip not detected

[Orange Double blink then pause], Binding mode enabled

[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration

[Solid single color Connected to a transmitter], color indicates packet rate