Inicio

Filtros activos

  • Categorías: Back In Stock
  • Categorías: Ropa
  • Disponibilidad: En stock
20,62 €
En stock

RGB LED Status

[Rainbow fade effect], Starting Up

[Green heartbeat], Web update mode enabled

[Slow blink 500ms on/off ], Waiting for connection from transmitter

[Red flashing 100ms on/off], Radio chip not detected

[Orange Double blink then pause], Binding mode enabled

[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration

[Solid single color Connected to a transmitter], color indicates packet rate

49,55 €
En stock

PM20S-2 is made with 100V DC components.

Support 9V to 85V DC operating Input voltage with 85V TVS protection

2x independent Step-Down Voltage Regulators

Regulator 1 ,  5.3V / 6.1V / 8.1V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

Regulator 2 ,  5.3V / 8.1V / 12.2V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

1K:25K voltage divider built-in for 3.3V based voltage ADC

Size & Weight: 61x40x15mm, 63g

5,74 €
En stock

If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).

15,66 €
En stock

The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.

Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!