Home
Active filters
Radiomaster Boxer Radio Controller (M2)
Radiomaster 2S 7.4V 6200mAh Lipo Battery
Drone Waterproofing service
We waterproof your drone, and test it in a safe environment. If you choose this service, you don't have to worry about anything, we take care of organizing the pickup of the drone at your home, and we send it to you once it is waterproofed ¡Without extra charge!
RadioMaster 5000mAh 2s Li-ion battery pack
The RadioMaster 5000mAh 2s Li-ion battery pack is the perfect battery for your Radiomaster TX16S. Offering longer run times and safer use when compared to Li-poly batteries.
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
ES900RX 868MHz - Module by Happymodel
This Long Range 868MHz wireless transmission module is designed based on Open source software ExpressLRS. It is compatible with most OpenTX radios, especially the TX16S from Radiomaster.
Matek 2812 Led Controller V2
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).
Matek UBEC Duo, 4A/5-12V
Matek Power Module 20S
PM20S-2 is made with 100V DC components.
Support 9V to 85V DC operating Input voltage with 85V TVS protection
2x independent Step-Down Voltage Regulators
Regulator 1 , 5.3V / 6.1V / 8.1V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
Regulator 2 , 5.3V / 8.1V / 12.2V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
1K:25K voltage divider built-in for 3.3V based voltage ADC
Size & Weight: 61x40x15mm, 63g
Matek Power Module 12S
Wide 9V to 55V Operating Input Range with TVS protection
3x independent Step-Down Voltage Regulators
BEC Vx, 5.2V / 6V / 8V output options. supports typical continuous output current of up to 15A, Peak current of up to 25A.
BEC 5V (Fixed), 4A continuous
BEC 12V (Fixed), 4A continuous
1K:20K voltage divider built-in (Volt = 1/21 Input voltage)
Current sensor signal passthrough pad
Size & Weight: 61x40x15mm, 53g
Matek Optical Flow 3901-L0X
Communication between 3901-L0X module and Flight controller via UART MSP V2 protocol supported by INAV and ArduPilot.
There is no detailed datasheet of MSP V2 protocol.
TBS Tango 2 Replacement Oled
The Tango 2 replacement oled.
TBS Tango 2 Replacement Switch
Replacement switch for the page and exit buttons. Can be also used for switch E and F