Home
Active filters
HQProp Bonnet
Winter bonnet for the cold days flying your drone.
HQProp Cap
HQProp Cap.
FETtec OSD Board
FETtec OSD Board. Full KISS tunning, live data graphs (Voltage, motor rpm, current, motor temp, gyro values, link quality).
FETtec Race Wire 6 (2 pcs.)
HQProp Velcro Strap 30X1.6 CM (2PCS)(metal)
HQProp Velcro Strap 25X1.6 CM (2PCS)(metal)
HQProp Velcro Strap 21X1.6 CM (2PCS)(metal)
FETtec Tiny LED Stick (2 pieces)
FETtec Tiny LED Stick (2 pieces)
Mateksys PDB FCHUB-12S V2
PDC
Input voltage range: 8~60V (3~12S LiPo)
4x70A continuous, 4x110A burst
4x ESC power /signal/ telemetry pads
Current Senor: 440A, 3.3V ADC, Scale 75
2x LED indicators for 5V, 12V
1K:20K voltage divider built-in
Matek Hall effect-Current sensor
Matek DroneCAN Magnetometer RM3100
CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
Matek DroneCAN-Digital power monitor
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
Matek 2812 Led Controller V2
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).