Home
Active filters
Matek UBEC Duo, 4A/5-12V
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
Matek ELRS 2.4G True Diversity RX
RGB LED Status
[Rainbow fade effect], Starting Up
[Green heartbeat], Web update mode enabled
[Slow blink 500ms on/off ], Waiting for connection from transmitter
[Red flashing 100ms on/off], Radio chip not detected
[Orange Double blink then pause], Binding mode enabled
[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration
[Solid single color Connected to a transmitter], color indicates packet rate
Matek Optical Flow 3901-L0X
Communication between 3901-L0X module and Flight controller via UART MSP V2 protocol supported by INAV and ArduPilot.
There is no detailed datasheet of MSP V2 protocol.
Matek Power Module 12S
Wide 9V to 55V Operating Input Range with TVS protection
3x independent Step-Down Voltage Regulators
BEC Vx, 5.2V / 6V / 8V output options. supports typical continuous output current of up to 15A, Peak current of up to 25A.
BEC 5V (Fixed), 4A continuous
BEC 12V (Fixed), 4A continuous
1K:20K voltage divider built-in (Volt = 1/21 Input voltage)
Current sensor signal passthrough pad
Size & Weight: 61x40x15mm, 53g
Matek Power Module 20S
PM20S-2 is made with 100V DC components.
Support 9V to 85V DC operating Input voltage with 85V TVS protection
2x independent Step-Down Voltage Regulators
Regulator 1 , 5.3V / 6.1V / 8.1V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
Regulator 2 , 5.3V / 8.1V / 12.2V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
1K:25K voltage divider built-in for 3.3V based voltage ADC
Size & Weight: 61x40x15mm, 63g
Matek 2812 Led Controller V2
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).
TBS Unify Pro32 Nano 5G8 V1.1
With the TBS UNIFY PRO32 Nano we have boosted the output power, improved the robustness, decreased the power consumption, added capability for insane features and perfected the way it is installed in your multirotor. In a nutshell, it’s the most comprehensive, future proof, highest quality and overall best nano VTx ever made.
Matek H7A3-Slim Flight Controller
Ethix Mini FPV Screen
FPV watch with 48 channels and band scan.
Drone Waterproofing service
We waterproof your drone, and test it in a safe environment. If you choose this service, you don't have to worry about anything, we take care of organizing the pickup of the drone at your home, and we send it to you once it is waterproofed ¡Without extra charge!
TBS Crossfire Immortal T V2 Antenna
We have managed to improve the immortal T on durability and signal sensitivity.
Radiomaster 2S 7.4V 6200mAh Lipo Battery
5.8GHz Vitenna 8dBi Directional Antenna RHCP
Defy Gravity With This Exciting IFTRON Circularly Polarized Exclusive! Say ‘Hi’ to Vitenna©. No more antenna mounting and aiming hassles! We’ve designed Vitenna© with a special, gooseneck coax. The gooseneck supports the antenna all by itself. Just tighten the connector onto your receiver SMA and then bend the stem to aim Vitenna as you wish…and it stays put by itself! What could be simpler and easier?