Home
Active filters
Antivibration dampers for flight controller with M2 holes.
Antivibration dampers for flight controller with M2 holes.
BETAFPV Meteor85 Brushless Whoop Quadcopter
Meteor85 brushless whoop quadcopter, optimized weight, provides a smoother flight experience that's easier to control at high speed and easier on battery life as well. This new Meteor85 (2022) has been upgraded from its frame, canopy, props, battery, flight controller, and camera, offering pilots up to 7 mins flight time and stable flying for freestyle tricks. With the combination of those electronics and parts, it reaches the best balance between performance, weight, durability, and premium build design.
BetaFPV Aquila 16 FPV KIT
The Aquila16 FPV kit is a more advanced kit for beginners. It's an inverted quadcopter with a modular aerodynamic design. Fly for up to 8 mins, covering a maximum distance of 200 meters. Enjoy stable hovering and enhanced frame protection, allowing for consistent flight practice and better control. The kit includes the VR03 FPV Goggles for recording your flying and a Literadio 2 SE Radio Transmitter with the latest ELRS 3.0 firmware. All you need is in one pack! Accelerate your FPV learning curve and become a pro sooner with this kit.
iFlight Protek 25 Analog Kit RTF
This kitcontains: 1 x Analog Protek 25 ELRS, 1 x Literadio 3 ELRS, 1 x Betafpv VR03, 2 x CNHL Ministar 850mAh 4S, 1 x Toolkit RC M6.
Xhelix Bandeja magnética
Mateksys PDB FCHUB-12S V2
PDC
Input voltage range: 8~60V (3~12S LiPo)
4x70A continuous, 4x110A burst
4x ESC power /signal/ telemetry pads
Current Senor: 440A, 3.3V ADC, Scale 75
2x LED indicators for 5V, 12V
1K:20K voltage divider built-in
Matek Hall effect-Current sensor
Matek DroneCAN Magnetometer RM3100
CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
Matek DroneCAN-Digital power monitor
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
ToolkitRC ADP 200 AC to DC Adapter
Input voltage:AC 100-240V 50/60Hz
Input current:MAX 2.5A
Output voltage:MAX 19.5V
Output current:MAX 10.3A
Connector:XT60
Size:165mm * 77mm * 32mm
Wight:518g
Work temp:-10 - 40'C