TBS Triumph Pro (SMA Stub)
€17.27
.png)
Don't miss it
HQ Racing Prop R42 Light Grey - Poly Carbonate
€2.21
€2.77
-20%
Home
Active filters
Capacitor Panasonic FC series 50V 120UF
€0.79
In stock
Condensador Panasonic FC series 50V 120UF
Capacitor Panasonic FC series 35V 680UF
€1.20
In stock
Capacitor Panasonic FC series 35V 680UF
Capacitor Panasonic FC series 50V 1200UF
€1.90
Reservation
Capacitor Panasonic FC series 50V 1200UF
Mamba Universal parts package
€3.30
Reservation
Set of components to mount any type of FC + ESC M2 or M3 stack in the absence of screws of the length you use.
Capacitor Panasonic FC series 50V 680UF
€1.36
In stock
Capacitor Panasonic FC series 50V 680UF
HQProp Velcro Strap 30X1.6 CM (2PCS)（metal)
€2.44
Reservation
HQProp Velcro Strap 25X1.6 CM (2PCS)（metal)
€2.27
In stock
HQProp Velcro Strap 21X1.6 CM (2PCS)（metal)
€2.11
In stock
Diatone Mamba Soldering Practice Board
€2.27
Reservation
Mateksys PDB FCHUB-12S V2
€23.10
In stock
PDC
Input voltage range: 8~60V (3~12S LiPo)
4x70A continuous, 4x110A burst
4x ESC power /signal/ telemetry pads
Current Senor: 440A, 3.3V ADC, Scale 75
2x LED indicators for 5V, 12V
1K:20K voltage divider built-in
Matek Hall effect-Current sensor
€15.66
In stock
Matek DroneCAN Magnetometer RM3100
€33.02
In stock
CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
Matek DroneCAN-Digital power monitor
€26.40
In stock
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
Matek Loud Buzzer 5V
€4.09
In stock
5V Buzzer for your flight controller
Matek 2812 Led Controller V2
€5.74
In stock
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).