Home
There are 74 products.
Active filters
TBS Battery Anti-slip Pad (3pcs)
Super grippy, sticky battery pads for different size quads (cut to your own size).
TBS All-Purpose 24 Bit Driver Kit
Sometimes you got that special project with special screws you dont have bits for. This 24bits kit might be able to help you out. Any workbench should have a set just in case!
SpeedyBee Adapter 3
SpeedyBee 4pcs FPV Soldering Practice Board
Soldering Mini Stand With Clean Sponge
Soldering Mini Stand With Clean Sponge
Smoke Stopper Amass XT60 XT30
The Smoke Stopper offers much lower trip and hold currents as well as faster reaction time. We also provide a wider variety of input voltages and input and output connectors than any other smoke plug!
Replacement Soldering Iron Tips For SQ-001, SQ-D60 Soldering Iron
Micro Battery Anti-slip Pad (5pcs)
Super grippy, sticky battery pads for your micro builds.
Mateksys PDB FCHUB-12S V2
PDC
Input voltage range: 8~60V (3~12S LiPo)
4x70A continuous, 4x110A burst
4x ESC power /signal/ telemetry pads
Current Senor: 440A, 3.3V ADC, Scale 75
2x LED indicators for 5V, 12V
1K:20K voltage divider built-in
Matek Hall effect-Current sensor
Matek DroneCAN-Digital power monitor
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
Matek DroneCAN Magnetometer RM3100
CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
LiPo Killer 0V XT60 XT30
The 0V lithium battery discharger is a discharger designed to completely disintegrate the discharge capacity of a lithium battery.
Kotking Water Splashproof Coating for R/C Drone - 15 ml
The best coating for the electronics of your drone and make it waterproof. The coating is easy to remove for repairs or component replacement. The product is 15 ml, enough for coating all the electronics of 2-3 drones.
KitCopter Velcro Strap Kevlar V2 - 30x2 cm negro
KitCopter Velcro Strap Kevlar V2 - 30x2 cm negro