TBS Triumph Pro (SMA Stub)
€17.27
.png)
Don't miss it
HQ Racing Prop R42 Light Grey - Poly Carbonate
€2.21
€2.77
-20%
Home
Active filters
Matek UBEC Duo, 4A/5-12V
€16.49
In stock
Matek Loud Buzzer 5V
€4.09
In stock
5V Buzzer for your flight controller
Matek ELRS 2.4G True Diversity RX
€20.62
In stock
RGB LED Status
[Rainbow fade effect], Starting Up
[Green heartbeat], Web update mode enabled
[Slow blink 500ms on/off ], Waiting for connection from transmitter
[Red flashing 100ms on/off], Radio chip not detected
[Orange Double blink then pause], Binding mode enabled
[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration
[Solid single color Connected to a transmitter], color indicates packet rate
Matek Optical Flow 3901-L0X
€24.75
In stock
Communication between 3901-L0X module and Flight controller via UART MSP V2 protocol supported by INAV and ArduPilot.
There is no detailed datasheet of MSP V2 protocol.
Matek Power Module 12S
€27.23
In stock
Wide 9V to 55V Operating Input Range with TVS protection
3x independent Step-Down Voltage Regulators
BEC Vx, 5.2V / 6V / 8V output options. supports typical continuous output current of up to 15A, Peak current of up to 25A.
BEC 5V (Fixed), 4A continuous
BEC 12V (Fixed), 4A continuous
1K:20K voltage divider built-in (Volt = 1/21 Input voltage)
Current sensor signal passthrough pad
Size & Weight: 61x40x15mm, 53g
Matek Power Module 20S
€49.55
In stock
PM20S-2 is made with 100V DC components.
Support 9V to 85V DC operating Input voltage with 85V TVS protection
2x independent Step-Down Voltage Regulators
Regulator 1 , 5.3V / 6.1V / 8.1V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
Regulator 2 , 5.3V / 8.1V / 12.2V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
1K:25K voltage divider built-in for 3.3V based voltage ADC
Size & Weight: 61x40x15mm, 63g
Matek 2812 Led Controller V2
€5.74
In stock
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).
Matek H7A3-Slim Flight Controller
€56.16
In stock
HQProp R31 (5131)
€2.31
In stock
Propeller Diameter: 5.1inch
Pitch : 3.1
Blades : 3
Material : Poly Carbonate
Weight :4.2g
Hub Diameter :13.3mm
Hub Thickness:6.3mm
Shaft :5mm
Adaptor Rings : NO
Includes
2 x CW R31-PC
2 x CCW R31-PC
HQProp Cap
€3.45
€5.74
-40%
In stock
HQProp Cap.
Mateksys Flight Controller F405-HDTE
€57.81
In stock