TBS Triumph Pro (SMA Stub)
€17.27
.png)
Don't miss it
HQ Racing Prop R42 Light Grey - Poly Carbonate
€2.21
€2.77
-20%
Home
Active filters
Matek ELRS 2.4G True Diversity RX
€20.62
In stock
RGB LED Status
[Rainbow fade effect], Starting Up
[Green heartbeat], Web update mode enabled
[Slow blink 500ms on/off ], Waiting for connection from transmitter
[Red flashing 100ms on/off], Radio chip not detected
[Orange Double blink then pause], Binding mode enabled
[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration
[Solid single color Connected to a transmitter], color indicates packet rate
Matek H7A3-Slim Flight Controller
€56.16
In stock
Kotking Water Splashproof Coating for R/C Drone - 15 ml
€11.49
In stock
The best coating for the electronics of your drone and make it waterproof. The coating is easy to remove for repairs or component replacement. The product is 15 ml, enough for coating all the electronics of 2-3 drones.
Mamba MSR SBUS/CPPM D16 16CH ACCST Receiver
€13.31
€15.66
-15%
In stock
Mateksys Flight Controller F405-HDTE
€57.81
In stock
Matek FC H743-Wing V3
€103.26
In stock
The Mateksys H743 series of flight controllers has all the power of the F7 processor, but the H7 now has more ports. This autopilot has up to 13 PWM servo outputs, 7 UART port, 2 i2c and CAN port.
Matek FC F405-Wing V2
€43.76
In stock
Matek GNSS M10-L4-3100
€75.99
In stock
Matek F411-WTE
€32.98
In stock
Mateksys PDB FCHUB-12S V2
€23.10
In stock
PDC
Input voltage range: 8~60V (3~12S LiPo)
4x70A continuous, 4x110A burst
4x ESC power /signal/ telemetry pads
Current Senor: 440A, 3.3V ADC, Scale 75
2x LED indicators for 5V, 12V
1K:20K voltage divider built-in
Matek Hall effect-Current sensor
€15.66
In stock
Matek DroneCAN Magnetometer RM3100
€33.02
In stock
CAN-L4-3100 is a professional grade CAN Magnetometer based on RM3100 & ArudPilot AP_Periph firmware.
Matek DroneCAN-Digital power monitor
€26.40
In stock
CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.
With this device, No calibration required, flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.
Matek Loud Buzzer 5V
€4.09
In stock
5V Buzzer for your flight controller
Matek 2812 Led Controller V2
€5.74
In stock
If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).