Home
Active filters
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
Tattu Large Lipo Battery Strap - 25x550mm (1pc)
A Tattu Lipo Strap XL. Large in size, best suited for 6s sized batteries. The Tattu hook and loop battery straps are a great accessory for almost any multi rotor platform. These "XL" size straps are 550mm long x 25mm wide.
Tattu R-Line 550mAh 11.1V 3S1P 95C Lipo Battery with XT30
Tattu R-Line 3S 550mAh 11.1V 95C Lipo Battery is suitable for Diatone GT R369 349 3 inch Toothpick size Quad.
Matek H743-SLIM V3
Matek GPS ublox SAM-M8Q
Ublox SAM-M8Q GPS, GLONASS, Galileo, QZSS and SBAS receiver with antenna. For your UAV systems, Robots, RC, FPV or other projects.
Matek Flight Controller F405-miniTE
STM32F405RGT6, ICM42605, SPL06, OSD, 6x UARTs, 1x I2C, 12x PWM outputs, BEC 5V & 10V.
Matek F405-WMN
Matek H7A3-Slim Flight Controller
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
Matek UBEC Duo, 4A/5-12V
Matek Power Module 20S
PM20S-2 is made with 100V DC components.
Support 9V to 85V DC operating Input voltage with 85V TVS protection
2x independent Step-Down Voltage Regulators
Regulator 1 , 5.3V / 6.1V / 8.1V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
Regulator 2 , 5.3V / 8.1V / 12.2V output options. supports typical continuous output current of up to 15A, Peak current of up to 22A.
1K:25K voltage divider built-in for 3.3V based voltage ADC
Size & Weight: 61x40x15mm, 63g
Matek Power Module 12S
Wide 9V to 55V Operating Input Range with TVS protection
3x independent Step-Down Voltage Regulators
BEC Vx, 5.2V / 6V / 8V output options. supports typical continuous output current of up to 15A, Peak current of up to 25A.
BEC 5V (Fixed), 4A continuous
BEC 12V (Fixed), 4A continuous
1K:20K voltage divider built-in (Volt = 1/21 Input voltage)
Current sensor signal passthrough pad
Size & Weight: 61x40x15mm, 53g