Home

Active filters

  • Categories: Back In Stock
  • Categories: FPV
  • Categories: Frames
  • Availability: Available
  • Availability: Not available
€20.62
In stock

RGB LED Status

[Rainbow fade effect], Starting Up

[Green heartbeat], Web update mode enabled

[Slow blink 500ms on/off ], Waiting for connection from transmitter

[Red flashing 100ms on/off], Radio chip not detected

[Orange Double blink then pause], Binding mode enabled

[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration

[Solid single color Connected to a transmitter], color indicates packet rate

€22.23
In stock

The SOURCE TWO is the 2nd open source frame, this time focusing on lightweight and racing. The frame is donated to the community to empower creators and makers, and integrate best practices and current trends faster into a continuously manufactured product.

€24.79
Out of Stock

The most advanced 5.8GHz Video Transmitter available today. Only 4 grams, and a slender 31 x 20mm, the TrampHV is also the smallest direct LiPo-powered vTx in the business. 

Supporting touch-free 'TNR' wands, for low inter-heat times, and full Tx configuration with a bright OLED display. (Accesory sold separately)

€27.23
In stock

Wide 9V to 55V Operating Input Range with TVS protection

3x independent Step-Down Voltage Regulators

BEC Vx,  5.2V / 6V / 8V output options.  supports typical continuous output current of up to 15A, Peak current of up to 25A.

BEC 5V (Fixed), 4A continuous

BEC 12V (Fixed), 4A continuous

1K:20K voltage divider built-in (Volt = 1/21 Input voltage)

Current sensor signal passthrough pad

Size & Weight: 61x40x15mm, 53g

€24.79
Out of Stock

The original Tramp HV was released in 2016, and pushed the boundaries of what was possible with an Analog 5.8GHz FPV Transmitter. 

The Tramp Nano is the smaller cousin, more suited to today’s lightweight models. 

Control via Betaflight telemetry (Tramp Mode), button, or Touch’n’Race wand. 

€49.55
In stock

PM20S-2 is made with 100V DC components.

Support 9V to 85V DC operating Input voltage with 85V TVS protection

2x independent Step-Down Voltage Regulators

Regulator 1 ,  5.3V / 6.1V / 8.1V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

Regulator 2 ,  5.3V / 8.1V / 12.2V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

1K:25K voltage divider built-in for 3.3V based voltage ADC

Size & Weight: 61x40x15mm, 63g

€5.74
In stock

If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).

€28.02
In stock

With the TBS UNIFY PRO32 Nano we have boosted the output power, improved the robustness, decreased the power consumption, added capability for insane features and perfected the way it is installed in your multirotor. In a nutshell, it’s the most comprehensive, future proof, highest quality and overall best nano VTx ever made.