Home
Active filters
HQProp Bonnet
Winter bonnet for the cold days flying your drone.
Matek UBEC Duo, 4A/5-12V
Diatone Roma F5 5inch Freestyle Frame Kit
Effortlessly become one with the wind with the Roma series, created using excellent craftsmanship and surpassing its freestyle predecessors. Fly the Roma frame to get maximum control over your FPV drone.
HQProp Cap
HQProp Cap.
Matek Loud Buzzer 5V
5V Buzzer for your flight controller
Black Sheep Beanie (Black)
TBS Beanie to keep your head warm during windy excursions.
Matek ELRS 2.4G True Diversity RX
RGB LED Status
[Rainbow fade effect], Starting Up
[Green heartbeat], Web update mode enabled
[Slow blink 500ms on/off ], Waiting for connection from transmitter
[Red flashing 100ms on/off], Radio chip not detected
[Orange Double blink then pause], Binding mode enabled
[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration
[Solid single color Connected to a transmitter], color indicates packet rate
Caddx Cap (Black)
Caddxfpv Cap (Black)
Matek Optical Flow 3901-L0X
Communication between 3901-L0X module and Flight controller via UART MSP V2 protocol supported by INAV and ArduPilot.
There is no detailed datasheet of MSP V2 protocol.
Gemfan Monkey Hat
Gemfan Monkey Hat
TBS Source Two V0.1
The SOURCE TWO is the 2nd open source frame, this time focusing on lightweight and racing. The frame is donated to the community to empower creators and makers, and integrate best practices and current trends faster into a continuously manufactured product.
ImmersionRC TrampHV
The most advanced 5.8GHz Video Transmitter available today. Only 4 grams, and a slender 31 x 20mm, the TrampHV is also the smallest direct LiPo-powered vTx in the business.
Supporting touch-free 'TNR' wands, for low inter-heat times, and full Tx configuration with a bright OLED display. (Accesory sold separately)
Matek Power Module 12S
Wide 9V to 55V Operating Input Range with TVS protection
3x independent Step-Down Voltage Regulators
BEC Vx, 5.2V / 6V / 8V output options. supports typical continuous output current of up to 15A, Peak current of up to 25A.
BEC 5V (Fixed), 4A continuous
BEC 12V (Fixed), 4A continuous
1K:20K voltage divider built-in (Volt = 1/21 Input voltage)
Current sensor signal passthrough pad
Size & Weight: 61x40x15mm, 53g
TBS Tango Lanyard
TBS Lanyard with buckle for quick detach.