Home
Active filters
Airbot Omnibus F4 V6
OMNIBUS F4's upgrade version, using F405 and new target, with 5x UARTs now.
classic OMNIBUS design, using F4 MCU controls OSD over SPI bus, compare the first version, we added BMP280 as barometer and SD Card supports.
OSD Configuration has been incl. in Betaflight GUI.
Matek Hall effect-Current sensor
Gaoneng 4S 1500mah 130c
The best Gaoneng 4S battery for racing.
Gaoneng 4S 1800mah 130C
4S battery
Gaoneng 6S 1250mah 120C
6S battery
Gaoneng 3S 300MAH 30C XT30
3S battery.
Airbot cable 8 pins 3cm
The cable serves primarily to connect the FC and the 4in1 controllers.
Recommended accessories for Airbot products (and others with 8-pin connector)
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Airbot Omnibus F4 V6 + Furling32 4in1 45A
Mateksys BEC12S-PRO, 9-55V to 5/8/12V-5A
About this product
The MATEKSYS 12S Pro BEC features a wide 9-55V Operating Input Range, 3x Output Voltage Options 5V/8V/12V and Supports continuous output current of up to 5A, peak current of 9A. This voltage regulator also features a synchronous switching step-down (buck) regulator, thermal Shutdown, output Short-circuit tolerance (2 seconds), overcurrent protection & self-recovery and much more!
Airbot Furling32 4in1 mini ESC HC - F3 32bit BLHELI ESC 4x55A
New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed.
Supports up to 60A burst and 55A continued.
Airbot OMNIBUS F4 Nano v7
A new generation AIO Flight control for FPV, based on F405 MCU, using F4 MCU controls OSD over SPI bus in DMA mode, Supports 6x UART
Matek H743-SLIM V3
Matek GPS ublox SAM-M8Q
Ublox SAM-M8Q GPS, GLONASS, Galileo, QZSS and SBAS receiver with antenna. For your UAV systems, Robots, RC, FPV or other projects.
Matek Flight Controller F405-miniTE
STM32F405RGT6, ICM42605, SPL06, OSD, 6x UARTs, 1x I2C, 12x PWM outputs, BEC 5V & 10V.