Home

Active filters

  • Categories: 3D prints
  • Categories: Back In Stock
  • Categories: Deals
  • Categories: FPV
€8.19
Reservation

We provide various TPU mounts for your GoPro (Nazgul5, TBS Source One V3...). In case of needing a specific mount, let us know your requirements and we will gladly design a piece that suits you. To specify the wanted 3D print write a message in your order.

€10.99
Reservation

We provide various TPU frame pieces (Nazgul5, TBS Source One V3...). In case of needing a specific piece, let us know your requirements and we will gladly design a piece that suits you. To specify the wanted 3D print write a message in your order.

€20.62
In stock

RGB LED Status

[Rainbow fade effect], Starting Up

[Green heartbeat], Web update mode enabled

[Slow blink 500ms on/off ], Waiting for connection from transmitter

[Red flashing 100ms on/off], Radio chip not detected

[Orange Double blink then pause], Binding mode enabled

[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration

[Solid single color Connected to a transmitter], color indicates packet rate

€49.52
€61.90 -20%
In stock

In a race, microseconds count. Goggles down, thumbs up - are you ready for a true 250Hz radio link? End to end latency: barely noticeable. Nothing else comes close! Thanks to 2.4GHz technology, we took the best from Crossfire and shrunk it down to speed it up. The end result: Smaller antennas, more speed, range for days.

€24.79
Out of Stock

The most advanced 5.8GHz Video Transmitter available today. Only 4 grams, and a slender 31 x 20mm, the TrampHV is also the smallest direct LiPo-powered vTx in the business. 

Supporting touch-free 'TNR' wands, for low inter-heat times, and full Tx configuration with a bright OLED display. (Accesory sold separately)

€27.23
In stock

Wide 9V to 55V Operating Input Range with TVS protection

3x independent Step-Down Voltage Regulators

BEC Vx,  5.2V / 6V / 8V output options.  supports typical continuous output current of up to 15A, Peak current of up to 25A.

BEC 5V (Fixed), 4A continuous

BEC 12V (Fixed), 4A continuous

1K:20K voltage divider built-in (Volt = 1/21 Input voltage)

Current sensor signal passthrough pad

Size & Weight: 61x40x15mm, 53g

€24.79
Out of Stock

The original Tramp HV was released in 2016, and pushed the boundaries of what was possible with an Analog 5.8GHz FPV Transmitter. 

The Tramp Nano is the smaller cousin, more suited to today’s lightweight models. 

Control via Betaflight telemetry (Tramp Mode), button, or Touch’n’Race wand. 

€49.55
In stock

PM20S-2 is made with 100V DC components.

Support 9V to 85V DC operating Input voltage with 85V TVS protection

2x independent Step-Down Voltage Regulators

Regulator 1 ,  5.3V / 6.1V / 8.1V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

Regulator 2 ,  5.3V / 8.1V / 12.2V output options.  supports typical continuous output current of up to 15A, Peak current of up to 22A.

1K:25K voltage divider built-in for 3.3V based voltage ADC

Size & Weight: 61x40x15mm, 63g