List of products by brand Matek

€5.74
In stock

If you are looking to add LED lighting to your racing drone the Matek 2812 lighting systems provides a neat plug and play solution. The setup consist of the Matek 2812 LED Controller (this product) and RGB LED Strips available separately – here. The controller boasts seven colour options and seven flashing modes. It has four output channels, so one for each arm on a quadcopter and supports control of up to 48 LEDs in total (12 per channel).

€26.40
In stock

CAN-L4-BM is a ultra-precise digital power monitor based on TI INA239 & ArudPilot AP_Periph firmware. The resistance of this conductive path is 200 μΩ typical, providing low power loss in the application.

With this device, No calibration required,  flight controller that support DroneCAN protocol can easily get accurate current & bus voltage readouts via CAN bus.

€20.62
In stock

RGB LED Status

[Rainbow fade effect], Starting Up

[Green heartbeat], Web update mode enabled

[Slow blink 500ms on/off ], Waiting for connection from transmitter

[Red flashing 100ms on/off], Radio chip not detected

[Orange Double blink then pause], Binding mode enabled

[Orange Triple blink then pause], Connected to transmitter but mismatched model-match configuration

[Solid single color Connected to a transmitter], color indicates packet rate

€103.26
Reservation

The Mateksys H743 series of flight controllers has all the power of the F7 processor, but the H7 now has more ports. This autopilot has up to 13 PWM servo outputs, 7 UART port, 2 i2c and CAN port.

€37.15
In stock

The MATEKSYS M10-5883 supports GNSS (GPS, GLONASS, Galileo, and BeiDou), offers great RF sensitivity, will help you pick up the best signals, and can improve the dynamic position accuracy with small antennas or in non-line-of-sight scenarios.